Search Documents

By T. M. Dyhr, T. E. Wilson

Although environmental management costs during mine operation depend on the size, type, climatic and geochemical conditions of operation, general cost categories are identified and mean values, as a percentage of total operating cost, are determined for coal and non-coal surface and underground mines (medium-size) with on-site beneficiation and tailings disposal facilities. Cost trends are charted from 1963 through the present.

Jan 1, 2004

By Richard W. Kimball, Richard F. Coon

This paper describes drill and blast excavation and groundwater control measures at the Lake Mead Intake No. 2 project. The construction includes a deep access shaft, intake shaft, surge chamber, forebay chamber, intake tunnel, 22 well shafts and East Tunnel. Grouting ahead of the excavation face was used extensively during shaft and tunnel construction. Lake Mead Intake No. 1 was constructed in the early 1970’s under less severe groundwater conditions and this work was delayed by ground conditions and water control problems. Excavations for Lake Mead Intake No. 2 must be completed in 23 months to meet SNWA’s water delivery schedule.

Jan 1, 1999

By David E. Thompson, Edward S. Plotkin

The Massachusetts Bay Transportation Authority (MBTA) Red Line Extension Northwest is nearing the final stages of construction. The 3. 1 mile extension of the Red Line from the existing Harvard Square Station in Cambridge, Massachusetts to Alewife Brook Parkway in Cambridge, includes a large, near surface, hard rock, rapid transit chamber at Porter Square in Cambridge (Figure 1).

Jan 1, 1983

By Qingxia Liu, Chen Tingzhong, Chen Jin, Yang Xiaosheng

It is common problem (Huan Xinsheng, etc.,l992)for most iron ore concentrators in China that the concentration of thickened tailings is lower than the need for economical transportation. To solve the problem, two methods of improving the properties of the existing thickeners and using separate thickening technique have been applied in three iron ore concentrators. However, in the case of the Daye iron concentrator a new technique of cyclone-flocculated sedimentation was developed by present authors and verified by experiments. The new technique employs efficient hydrocydone designed by authors in conjunction with a low cost flocculant named KLP.

Jan 1, 1995

By K. D. Allen, M. J. Blattman

The problem of measuring the amount of rock removed during a given time interval is faced by most mining operations. Many methods have been developed with varying degrees of success, dependent upon the mining method and the availability of usable data. The Rosebud Mine has been in production for nearly two years, employing several techniques to estimate monthly production from underground production stopes. The use of three-dimensional solids generated from survey data has greatly improved the reliability and confidence of monthly production reports. The authors will summarize the methodology currently being utilized at Rosebud.

Jan 1, 1999

By M. Kaya

The main purpose of this study was to design a modular/mobile coal preparation plant with a capacity of 300 t/h for Seyitömer B3 vein (almost 70% of the whole SLI deposit). Firstly, coal washing properties and washability curves were determined by sink and float tests. Then, equipment sizing, selection, flow sheet development, economic evaluation, investment and operating costs were determined for coarse (-150+18mm), fine (-18+0.5mm) and slime (-0.5+0.1mm) coals. Economic evaluation of the proposed flow sheet showed the feasibility and profitability of the investment.

Jan 1, 2006

By Haydn H. Murray

A hydrothermal bentonite located in the high Sierras in Nevada is being mined and processed for use as a natural dietary supplement. Because hydrothermal clay deposits are normally zoned and not uniform in composition, a special stockpile was constructed to assure uniformity of processed products. The stockpile of clay was layered and rectangular in shape. Channel samples were taken from 10 locations around the stockpile and were mixed and quartered to provide representative samples. The samples were then chemically and mineralogically analyzed. The results showed excellent uniformity. The mineralogy and chemical analyses will be discussed in the paper.

Jan 1, 2005

By Zhengbin Cheng, Wenguang Lu, Baoqi Sun, Jiaying Tang

This paper studied the flotation separation of feldspar, zircon and kyanite from quartz with a mixture of cationic and anionic collectors. Tests show that collector mixture has specially good effect, using it, the separation of these three silicate minerals from quartz can be successfully achieved at the natural pH value of tap water in the absence of any acid, fluoride and other inorganic reagents. The properties and characteristics of collector mixture were analysed. By means of IR-spectra, ESCA and AES, the action mechanism between collector mixture and minerals was throughoutly studied.

Jan 1, 1995

By Paolo Massacci, Marco de Nardis

SPL (Spent Pot Linings) are hazardous waste. The described work seeks to identify simple and inexpensive processes for recovering the recyclable materials and thereby both reduce the volume to be handed to the dumps and produce a waste that belongs to a less dangerous class. For this purpose a study was conducted to characterise the structure of the cell and the refilling elements at the end of the Aluminum process. The properties of the material that make up the SPLs were determined in order to apply the related selection procedures. The study permitted the design of treatment process able to reduce the negative environment impact of the aluminum production cycle.

Jan 1, 1995

By Q. X. Yun, S. H. Liu

This paper provides a new approach to determine the opening layout in underground mining methods by means of genetic programming. Based on a set of random combination of openings, the layout of openings will gradually improve with the help of genetic operations, including reproduction, crossover, mutation and fitness calculation. The optimal solution will finally emerge according to Darwinian principle: "the survival of the fittest ".

Jan 1, 2002

By B. Day, L. Elinson

There is general agreement among those involved in occupational and public health that work-related diseases are under-diagnosed and under-reported. Highmark is particularly well positioned to carry out industry health analysis as it provides medical insurance for approximately three quarters of the insured population of Western Pennsylvania including some of the areas largest employers. The purpose of this study is to gain a more accurate understanding of the mining industry rates of respiratory diseases that maybe occupationally related and identify those inflated respiratory disease and hearing loss rates. Conditions examined included COPD, asthma, and pneumoconiosis.

Jan 1, 2004

By Thomas F. Pugsley, Wilf J. Davies, James Gallagher

Falconbridge Limited is developing a major nickel mine at Craig which lies between 600 m, 915 m and 1500 m below surface and is accessed on the 600 m and 1250 m levels of Onaping Mine. To supply adequate ventilation for mine development and initial ore production, two raises, 1200 m long are to be driven in norite and granitic gneiss. Falconbridge has purchased a Robbins 97RL Raise Drill and a string of 330 mm drill pipe to ream these raises in 600 m legs at diameter. The paper describes the introduction of deep hole, large diameter raise boring technology into Falconbridge operations involving contractors and specialists in the technology.

Jan 1, 1989

By Isobel Clark

The four papers in this session illustrate two different directions in which computer graphics seem to be developing. The first of these is in the handling and storage of geological information. The increasing use of micro-computers with limited storage facilities has seen a concomitant increase in the need to store geological data in as efficient a form as possible. It has also seen a recognition of the particular types of data which are used in a geological or mining analysis. Unlike many other fields, observations of drill cores, geological interpretations, structure and many other variables require storage in a readily accessible form. The authors of two papers in this session deal directly with Geological Information Systems. They discuss the setup, the specification of such systems, and the practical uses of the systems once in operation.

Jan 1, 1989

By C. Copeland, S. Kawatra

Airborne particulates can be generated by combustion processes, comminution, or materials handling, and regulation of these particulates by EPA are becoming progressively more stringent. Regulations will soon include “nanoparticulates,” particles finer than 100 nanometers, which are believed to have significant health effects due to their high surface area and reactivity. Although it was argued that nanoparticulate concerns were only important for combustion, studies here have shown that material handling and comminution release significant quantities of nanoparticles into the air. Laboratory studies have shown that sodium metasilicate reduced airborne particles finer than 10 micrometers (PM10) by 86% and particles finer than 2.5 micrometers (PM2.5) by 80% for iron ore. Additional studies were conducted which revealed that nanoparticulate emissions were present in the types of operations conducted at pyrometallurgical facilities.

Jan 1, 2007

By M. C. Fuerstenau

Collophane, cryptocrystalline fluorapatite, is examined as a substrate for plant water and wastewater remediation. The attenuation of Fe3+, Cr3+, Fe2+, Cd2+, Hg2+ and Pb2+ is presented as a function of metal ion concentration, amount of collophane, initial pH and conditioning time. TCLP results for Pb2+ contaminated collophane are presented. Mechanisms of adsorption for divalent and trivalent species are suggested. Key words: Collophane, Wastewater remediation, Heavy metal removal

Jan 1, 2003

By Michael C. Montoya, Craig Hopper

It has been well established that the ability to soft start a conveyor will give many benefits to the conveyor user. The effects of deceleration on belt tension have not been as extensively studied. This paper presents the findings of field measurements on the belt tension of a conveyor undergoing various rates of deceleration. The control of conveyor drive motors by Variable Frequency Drives (VFDs) allows the conveyor to be controlled during both acceleration and deceleration. The conveyor is allowed to ramp to a stop without putting unnecessary stress on the belt or conveyor structure.

Jan 1, 2000

The first of this two part series takes a look at some of the history and types of flotation as well as agents and mechanisms involved in it. Part two, next month, will examine flotation processes as applied to various sulfide and nonsulfide mineral ores. Flotation-"froth" flotation-is a physicochemical method of concentrating finely ground ores. The process involves chemical treatment of an ore pulp to create conditions favorable for the attachment of predetermined mineral particles to air bubbles. The air bubbles carry the selected minerals to the surface of the pulp, there forming a stabilized froth that is skimmed off and from which the predetermined mineral particles are recovered. Other minerals remain submerged in the pulp.

Jan 3, 1982

By G. K. Roset, L. R. Woodland, J. A. Stevenson, G. J. Hodges

The Stillwater Mining Co. (SMC) is a partnership of Pittsburg & Midway Coal Mining Co. and Manville Corp. Since the summer of 1990, SMC has operated a precious metals smelter at Columbus, MT for further upgrading of concentrates from its platinum-palladium mine. The facility's gas-cleaning system utilizes "oxidation/dilute-mode," dual-alkali scrubbing technology to capture sulfur oxide gases from the process gas streams. This paper describes the rationale for selecting the dilute-mode, dual-alkali system and summarizes the design parameters. Also discussed are the startup problems encountered and their solutions.

Jan 1, 1993

By V. Carabias-Hütter, A. J. Basu

The paper aims at promoting sustainability assessment and reporting into practice using a globally acceptable set of guidelines and a common framework for internal and external reporting at a project/site level. Indicators are used for measuring performance, and this paper addresses development and implementation of performance indicators for sustainability assessment and reporting at local as well as global levels. The selection of a proper set of indicators is a challenging task. The indicators selected should provide the expected information for making right decisions. Relevant and credible sustainability reporting supported by a consistent performance indicator system can be the starting point for benchmarking environmental and social performance for the natural resources sector.

Jan 1, 2004

By Ronald D. Hill

Acid mine drainage is the result of the oxidation of pyrite and similar iron sulfide material and the release of iron and sulfuric acid into the environment. In addition to the acid water flowing from underground and surface mines, spoil materials in surface mines are acidic and will not support good vegetative growth; thus erosion is a major problem. Lime and limestone are the major neutralizing agents used to treat these acidic conditions. Lime is the reagent preferred by industry for treating acid discharges, although a few companies use limestone. Agricultural lime- stone is used to "sweeten" acid spoils.

Jan 1, 1974