Search Documents

Recognizing the fact that the problems of the committee named by the Board to prepare the "official ticket" for officers and Directors of the Institute are various and difficult; and desiring to assist this committee by setting forth some of the principles that should guide the committee and some of the qualifications that should be required of candidates, the following instructions are formulated and the Secretary is directed to publish them in MINING AND METALLURGY concurrently with the publication of the names of each newly appointed Nominating Committee and to send a copy to each member of the, Committee.

Jan 1, 1946

By Joseph A. Newman

THE first trial of longhole drilling of raises began in June 1949 at the Holden mine, Chelan Div., Howe Sound Co. The cost of this raise was about the same as the average cost of raising by normal methods which was sufficiently encouraging to give the method further trial. At Holden, the Noranda method of blasthole drilling is used except that percussion drills have replaced diamond drills for making blastholes in all but certain special situations. Two thirds of these holes are between 40 and 70 ft long.

Jan 10, 1951

Recognizing the fact that the problems of the committee named by the Board to prepare the "official ticket" for officers and Directors of the Institute are various and difficult; and desiring to assist this committee by setting forth some of the principles that should guide the committee and some of the qualifications that should be required of candidates, the following instructions are formulated and the Secretary is directed to publish them in MINING AND METALLURGY concurrently with the publication of the names of each newly appointed Nominating Committee and to send a copy to each member of the Committee.

Jan 1, 1946

By J. Wright, R. J. Tyler

Abstract-Changes in the pore structure of hematite pellets during reduction to iron were investigated under a variety of experimental conditions. Pore structures were determined by a mercury penetration technique. The reduction temperature was found to be the major influence on structure, the pore system being bimodal below 750°C and unimodal above 900°C. Pore sizes ranging from 0.04 to 20 [um] were observed in completely metallized pellets produced over the temperature range 650-1050°C. Gas composition and reduction rates also influenced the pore structure of the metallized pellets, although to a lesser extent than the reduction temperature. An apparent activation energy of 24 kcal/mole was derived for the pore formation ptocess.

Jan 8, 1978

RESOLUTION ADOPTED BY "THE BOARD OF DIRECTORS AT ITS MEETING ON APRIL 17, 1936 Recognizing the fact that the problems of the committee named by the Board to prepare the "official ticket" for officers and Directors of the Institute are various and difficult; and desiring to assist this committee by setting forth some of the principles that should guide the committee and some of the qualifications that should be required of candidates, the following instructions are formulated and the Secretary is directed to publish them in MINING AND METALLURGY concurrently with the publication of the names of each newly appointed Nominating Committee and to send a copy to each member of the Committee.

Jan 1, 1942

Discussion of the paper of W. H. Gunniss, presented at the Butte meeting, August, 1913, and printed in Bulletin No. 81, September, 1913, pp. 2309 to 2310. PROF. J. W. RICHARDS, South Bethlehem, Pa. :-In regard to the physical nature of quartz for making silica brick, is the coarse-grained preferable ? E. P. MATHEWSON, Anaconda, Mont. :-A dense quartz is preferable. The quartzite is the actual material used by the Anaconda Company. The sandstone referred to, the foreign quartz, was a very pure sandstone and bad hardly any impurities in it, and the brick made from that particular material, while apparently beautiful while coming out of the kiln, and true, immediately on heating in the furnace buffed up half an inch and were cracked open.

Jan 11, 1913

Oct. 3, AIME, National Open Hearth. Southern Ohio Section, Deshler-Wallick Hotel, Columbus. Ohio. Oct. 10, AIME, Eastern Section, National Open Hearth Steel Committee, Harwich Hotel, Philadelphia. Oct. 15-17, Canadian Institute of Mining and Metallurgy, annual western meeting, Royal Alexandra Hotel, Winnipeg. Oct. 20-22, AIME, Institute of Metals Div., fail meeting with National Metal Congress. Hotel Adelphia, Philadelphia. Oct. 20-24, American Society for Metals, meeting with National Metal Congress, Benjamin Franklin Hotel, Philadelphia. Oct. 20-24, 40th National Safety Congress, Conrad Hilton, Congress, LaSalle. Morrison and Sheraton Hotels, Chicago. Oct. 24, Fall Meeting of Mining Branch of the Southern California Section, AIME, Statler Hotel, Los Angeles. Oct. 24, Illinois Mining Institute, annual meeting, Hotel Abraham Lincoln. Springfield. Ill.

Jan 1, 1952

By W. C. J. van Rensburg

Exploration of unconventional mineral resources is stimulated by uncertainties about the cost and security of conventional resource sup- plies. Costs of the latter are likely to increase as a result of inflation, higher energy costs declining productivity, a lack of sufficient investment in politically volatile areas, or through cartel-like action. Exploration of unconventional resources is likely to be delayed by these same factors, insufficient research and development facilities, and a decline in capital formation. World economic growth is likely to be slow, so there will be more emphasis on material conservation. Therefore, the incentive to explore for unconventional resources may be reduced.

Jan 1, 1983

By W. E. Lamont, G. V. Sullivan

As part of its program to conserve domestic mineral resources through advancing mineral resources technology, the US Department of the Interior, Bureau of Mines, conducted investigations to determine the feasibility of recovering high-grade barite concentrates, suitable for use as well-drilling mud, from current and old waste pond materials and materials bypassed in present mining operations. Flotation studies of waste pond samples from Missouri and Nevada yielded barite concentrates containing over 95% Bas04 with recoveries of 86% and 96%, respectively, of the barite in the flotation feed. Flotation studies of a hard-rock sample from Georgia, currently bypassed in mining, yielded a barite concentrate containing 97% Bas04 with an attendant recovery of97% of the barite.

Jan 1, 1982

By J. Avraamides

Many of the current methods for producing metallic silver particles having specific characteristics involve several steps, are time consuming and subject to contamination. The novel non-aqueous chemistry of silver and copper is used in a simple two step process capable of producing high purity silver powders of specific size and shape. The chemical basis of the process involves the manipulation of the equilibrium -- Cu(I1) + Ag [=]Cu(1) + Ag(1). The addition of at least 50% (V/V) acetonitrile (CH3CN) stabilizes both Cu(1) and Ag(1) ions in aqueous sulphate medium, and the metallic silver dissolves. Removal of the volatile nitrile by distillation reverses the equilibrium and silver powder is precipitated. The nature of the powder depends on the presence of additives such as gelatin, thiourea and polyacrylamide.

Jan 1, 1984

By Randall J. Essex

A massive mudslide blocked a river in Utah, impounding a 61 m (200 ft) deep lake. Under emergency conditions, a system was designed and constructed to: (1) drain the impounded lake; and (2) provide a permanent diversion for the river around the mudslide. The system consisted of a low level tunnel, a connecting vertical shaft daylighting close to the lake shore, control valves mounted within the tunnel, and an inlet channel between the lake and the shaft. This paper focuses on the problems and concerns surrounding the inlet channel excavation and the stabilization of the remaining vertical rock walls.

Jan 1, 1984

By C. Wegert, L. E. Paulson, S. A. Cooley, R. C. Ellman

The Grand Forks Energy Research Center (GFERC) and Commonwealth Edison of Chicago jointly conducted tests in which 400 tons of subbituminous and lignite coals were dried in a commercial scale dryer, oil sprayed and cooled, then shipped from Pekin, Ill., to Grand Forks, N.D., and stockpiled. Cars containing raw coal and dried coal which had not been sprayed, were also transported for comparative purposes. During transit, observations were made of changes in the coals' moisture content, dust losses, and temperature.

Jan 1, 1977

By F. B. Eiseman

IT is desired -to determine the effect of the extent of bank repairs on the final slag volume in acid electric steel-melting practice. It is understood that the repairs stud- TABLE I-Summary of Effect of Bank Repairs on Slag Volume [ ] ied here are necessary and the amount of sand added is that needed to maintain hearth and banks in a satisfactory condition. In this way the effect of repair materials on the amount of slag tapped would be found with a reasonable degree of accuracy. Ten heats were made for this study with careful attention to a uniform charge. The steel was the usual grade B and melting was carried out in a 3 1/2-ton top-charge Lectromelt furnace. Melting practice in all cases was the same-complete oxidation, with recarbonization by means of low-silicon pig iron.

Jan 1, 1947

ALL that I have been able to tell you concerning the ordinary practice of parting with aqua fords I have striven to demonstrate to you as briefly as possible. Now, before passing on to speak of other things, I wish to teach you the method that you must follow in order to recover whatever is good in those chalky precipitates of that acid and all the silver that you put in; it was for this reason that I told you to save them in a cucurbit by themselves. This is called "water of whites" by the master parters, and in reality is nothing other than the precipitates of thick phlegm of aqua fords, white as chalk. If these were not extracted from the acid, the spirits of the infused materials [69] would be almost without

Jan 1, 1942

By T. Y. Yan, W. F. Espewheid

The various ion exchange reactions occurring during restoration of formations contaminated with ammonia during in situ uranium leaching are reviewed. Data are presented on the restoration of a previously leached laboratory packed column wing lime saturated brine. Although this restoration fluid selectively and effectively removed the ammonia, 24.5 pore volumes are required to reduce the ammonia concentration from 500-3 mg/L (29- 0.18 gr per gal). The essence of NaCl in the restoration fluid at levels in formation water is beneficial in improving the selectivity of the system for NH4+ removal and reducing Ca + + ion consumption

Jan 1, 1984

By John P. Weir

Coal's participation in the domestic energy market depends to a very large extent upon the cost of coal delivered to consumers. Today the principal use of coal in the U.S. is in steam-electric generating stations. Generally, it is the delivered cost per million Btu's that is given the greatest weight in choosing either oil, natural gas or coal as the fuel used in these power plants. There are three major cost components of generating electric energy in steam-electric plants. These expenses expressed in terms of "dollars per kilowatt year" are: (1) operation and maintenance of necessary facilities, (2) fixed charges of necessary capital investment, and (3) fuel. For a modern large plant, the first two items would be approximately as follows:

Jan 9, 1962

By W. F. Mullen

WITH few exceptions, unit operations in the Pennsylvania slate industry in 1950 did not differ appreciably from production methods described by Behre1 and Bowles 2-4 several decades ago. Many traditionally picturesque but relatively inefficient hand operations continued to contribute to high operating costs in an industry in which the margin of profit, for various reasons, was admittedly low. As part of a general program in which the Pennsylvania State College has been assisting the slate industry to solve some of its problems, time and method studies were used in an effort to determine the bottlenecks of production flow. The results are as applicable to other stone industries as they are to slate.

Jan 12, 1951

By A. W. Ashbrook

The constraints which are being imposed on metallurgical operations in respect to the environment and worker hygiene are having a substantial influence on the various processes which are being studied and developed for future use. The unit process of solvent extraction can be no exception. It is therefore vital that sufficient be known about the effects of a solvent extraction process in terms of its environmental and hygiene impacts before the process gets to the construct- ion stage. The purpose of this section is to bring these matters to the readers' attention, and to indicate, albeit briefly, some of the problems, and what we know about the effects, of SX processes from an ecological point of view. Hydrocarbons Petroleum hydrocarbons are bio-degraded to form C02; several factors may limit the rate of bio-degradation, which are as follows:

Jan 1, 1978

By Edwin Chance

EDWARD H. Coxe, Knoxville, Tenn. (communication to the Secretary*).-Mr. Chance has omitted to mention one very important use for the chemist in connection with the preparation of coal, and that is in connection with coal washing. Efficient coal washing, and especially of the finer sizes, can be accomplished only under the supervision of a chemist, as the proper regulation of the washer can only be had by frequent sampling and analysis of the raw and washed product and the refuse, say at least semi-weekly; and only in this way can a check be kept on the quality of the product and the amount of good coal wasted in the refuse. In large operations, frequently enough coal can be saved from going to the refuse pile to more than pay the salary of the chemist.

Jan 12, 1916

By John J. Schanz

THE highly publicized shortage of students enrolled in engineering curricula has brought about a rapid increase in the enrollment in engineering schools in many parts of the country. Though most of the various curricula in the mineral industries field have participated in this increase, the experience at Pennsylvania State University has been that the nonmineral types of engineering have been increasing at a much more rapid rate than those in the College of Mineral Industries. [ ] It has been a matter of some concern to the staff of the College of Mineral Industries that enrollment in the curricula of the school has not been increasing at a rate commensurate with that experienced in the College of Engineering. If the lack of trained young graduates for our vital mineral industries is to be overcome, this situation must be remedied.

Jan 8, 1954