Search Documents

SAN FRANCISCO SECTION T. A. RICKARD, Chairman W. H. SHOCKLEY, Vice-Chairman C. E. GRUNSKY, JR., Secretary-Treasurer, 57 Post St., San Francisco, Cal. E. A. HERSAM H. W. YOUNG. A meeting of the San Francisco Section was held at the Engineers' Club of San Francisco on Mar. 28, 1916. Dr. Bailey Willis, Head of the Geological Department of Stanford University, read a paper on The Relation of the Major Structural . Features of the South American Continent to the Mineral Districts. Vice-Chairman Shockley interested the Section with an account of his experiences in South America. Discussion was participated in by C. F. Tolman, Jr., A. C. Lawson, Frank Probert, and E. A. Hersam. C. E. GRUNSKY, JR., Secretary.

Jan 5, 1916

By C. Morrow

Deformation studies were performed on tuffaceous rocks fran Yucca Mountain, Nevada Test Site to determine the strengths and coefficients of friction under confining pressures from 10-50 MPa at room temperature. Frictional strengths of 30ºsawcut samples increased with pressure and reached values of around 150 MPa at the higher confining pressures. However, the failure strengths of the intact samples were quite unpredictable. The coefficients of friction ranged between 0.7 and 0.9 for all specimens. These data can be used in conjunction with in situ stress measurements at Yucca Mountain, to evaluate the potential for earthquake activity in the region.

Jan 1, 1984

By William G. Kegel

Problems involved in putting the gob back underground in modern deep mines we dealt with. In particular, the problems associated with haulage of the gob back to the mine, the blown gob method of dispersion underground, and handling the refuse as slurry are discussed. Some alternative methods of disposal are presented.

Jan 1, 1976

By Martin F. Milligan

THIS short discussion of the effects of deoxidation on the mechanical properties of cast steels is intended to serve as general introduction to the subject of this afternoon's session. The subject is covered in detail in Mr. Carter's excellent paper. My material has been collected from the works of various investigators, several of whom are present today. For a definition of deoxidation, as applied to steel-furnace melting practice, we can best go to Briggs' book, "The Metallurgy of Steel Castings." Briggs says that deoxidation "includes all the phenomena in the final preparation of steel that would permit it to solidify free from gas cavities and from dissolved oxygen of all kinds." Various practices are used by welters to produce these end results.

Jan 1, 1947

By H. C. Fiedler

It was recently shown with 3.3 pct Si-Fe containing 0.026 pct S and 0.06 pct Mn that the extent of secondary recrystallization to a cube-on-edge texture is determined by the cooling rate from the solution temperature of the manganese sulfide inclusions.1 With a rapid cooling rate, many small inclusions rather than a few large ones are formed, which leads to increased restraint to normal grain growth and more complete secondary recrystalliza-tion. Strip samples 12 mils thick, rolled from 1-in.-thick slabs that were cooled at 130°C per min

Jan 1, 1964

The volumes of Transactions, which are published annually, contain the list of officers, rules, etc., the Proceedings, and the papers revised for final publication. (In this revision, after the preliminary publication, authors are permitted to use the largest liberty; and the changes and additions made in papers are sometimes important. It should be borne in mind by those who study or quote a paper in the preliminary edition, that they may not have in that form the ultimate and deliberate expression of the author's views. It should be added, however, that in the majority of cases there are no important changes.) These volumes are for sale as follows, in paper covers:

Jan 1, 1917

By S. C. Oliphant, C. R. Houssiere, George H. Fancher

DRILLING mud can be an item of great expense on the Gulf Coast. In order to understand the nature of a drilling mud, it is desirable to know the composition and size of the mineral particles that are present, The supercentrifuge has been adapted to the fractionation of mud, and this paper discusses the calibration and methods of operation and control. An alignment chart has been prepared, which was found useful in this work. Typical data are included, showing the comparative reliability of the method.

Jan 1, 1942

By C. Richard Tinsley, Ta M. Li

Accelerated development of the deep-ocean and continental margin resources may be the ultimate answer to meet rapidly increasing material demands to the year 2000. The mineral-rich oceans that have been described as "vast" and "nearly inexhaustible" have to date remained virtually untapped. Mineral Dependencies Trigger US Interests A lack of known domestic reserves of selected commodities and a climbing mineral trade deficit that reached a record $19 billion in 1974 are two factors that have sustained US interests in deep-ocean and offshore mining over recent years. But the lack of federal leadership in formulating ocean mining policy is said to have significantly discouraged the major capital commitments necessary to develop these resources.

Jan 4, 1975

By Cecil Hagen

All of the production for Ecuador during 1940 came from the Santa Elena Peninsula, Province of Guayas; the major portion coming from the Ancon field, which is controlled mostly by Anglo-Ecuadorian Oilfields, Ltd. A small amount was produced from the shallow pumpers and pozos, or oil pits, at Cautivo-Achallan, Carolina, Santa Paula, Concepcion, El Tambo and Mina Tigre. Considerable exploration was carried on in the country during 1940 and numerous concessions were in force, as shown by the accompanyiag map. Anglo-Saxon continued its exploratory work in the Oriente by surface geological methods and some geophysical surveys. It is understood that this concern did considerable airplane mapping. International Petroleum, on its large concessions between the Andes and Pacific Coast, did considerable surface work as well as some geophysical. No exploratory test wells were drilled by either of these

Jan 1, 1941

By J. S. Li, J. C. Edwards

A prediction is made of the airflow at the Bureau of Mines Lake Lynn Laboratory with a ventilation computer program that accounts for fan-driven forced ventilation and temperature-induced natural ventilation. There was substantial agreement between measured and predicted airflow rates. The capability of the program is demonstrated as a planning aid for ventilation under emergency conditions in a multilevel coal mine. Smoke spread in a multilevel mine is analyzed following the occurrence of two events, the failure of the main exhaust fan and the development of a fuel-rich fire in a passageway.

Jan 1, 1983

By C. D. Jardine, D. G. Patton

Rapidly increasing energy costs and more rigid customer quality requirements necessitate improved control of pelletizing processes. With the introduction of dedicated microprocessor-based controllers, sophisticated control strategies are now possible. An application of this technology at Carol Project has resulted in fuel savings, improved pellet quality, and standardization of operating procedures. This was accomplished with no production loss by using a "building block" approach to design and equipment selection.

Jan 1, 1985

Engineering Council has been elected to membership in the Chamber of Commerce of the United States. Its representative will be Mr. Harold W. Buck, of Viele, Blackwell & Buck, Consulting Engineers, New York City, Past-president of the American Institute of Electrical Engineers, his alternate being Mr. Irving E. Moultrop, of the Edison Electric Illum-inating Co., Boston, member of American Society of Mechanical Engin-eers and American Institute of Electrical Engineers. The Chamber of Commerce of the United States was formed in 1912 and now consists of more than 1100 organizations in every state of the union, in the out-lying possessions, and of all the principal American chambers of commerce abroad. One of the chief aims is to obtain the best business thought on national questions that concern business. Members of the National Chamber have the privilege of using all the facilities of the Chamber's offices in Washington when information is desired.

Jan 12, 1919

By William E. Ford, Edward Salisbury Dana

506. Scope of Descriptive Mineralogy. - It is the province of Descriptive Mineralogy to describe each mineral species, as regards: (1) form and structure; (2) physical characters; (3) chemical composition including blowpipe and chemical tests; (4) occurrence in nature with reference to geo- graphical distribution and association with other species; also in connection with the above to show how it may be distinguished from other species. Further, it should classify mineral species into more or less comprehensive groups according to those characters regarded as most essential. Other points which may or may not be included are the investigation of the methods of origin of minerals; the changes that they undergo in nature and the results of such alteration; also the methods by which the same compounds may be made in the laboratory; finally, the uses of minerals as ores, for ornament and in the arts.

Jan 1, 1922

By C. C. Clark, J. R. Mihalisin, K. G. Carroll

OBSERVATIONS made in this paper were for the purpose of exploring the anomalous behavior of a particular heat of Type 310 stainless steel. The alloy, of nominal composition 25 pct Cr, 20 pct Ni, was observed to form a grain boundary precipitate at exceedingly high rates. A sheet of this metal, 0.060 in. thick, after cooling in air from 2000°F showed the presence of the grain boundary material, whereas none was found after water-quenching from the same temperature. X-ray techniques were applied without success and, in view of the ex-

Jan 1, 1958

By D. E. Munson, H. J. Sutherland

Surface subsidence caused by underground mining is described through complementary influence functions. The complementary functions developed here differ from the simple functions previously used in that the surface displacement is the result of the combined contributions of the mined and unmined zones. This eliminates computational difficulties experienced with the simple functions in determining the deflections above the rib side and in the eventual application of influence functions to complex room-and-pillar configurations. Although the analysis framework presented is intended for predicting subsidence over complex mine configurations, use of the complementary functions is illustrated adequately by application to a longwall panel of the Old Ben No. 24 coal mine.

Jan 1, 1982

By Arthur F. Taggart

ENGINEERING is the art of control of men, matter, and energy in timely concert to provide economically the material needs of man. Control requires knowledge of the thing to be controlled and of proven methods of controlling. Knowledge of man comprises understanding of what he is and of his reactions as an individual and in the mass to his surroundings and to other men. Knowledge of matter comprises understanding of its fundamental nature, its methods of combining into multitudes of animate and inanimate forms, the properties of these forms and their various utilities, their sources and availability. Knowledge of energy constitutes knowing what is meant by the term, its various forms and sources, the laws of convertibility, and the methods of transformation and transmission.

Jan 4, 1950

By H. V. Fairbanks

Efforts were made to determine the amount of increase in the drying rate which could be obtained through acoustic treatment of ultra fine coal under various conditions, and to test the feasibility of using a rotary kiln and multitiered vibrating screens as a means for continuous drying of coal fines. Introduction of acoustic energy during the rotary kiln experiments increased the drying rates from 10-40%, depending upon the experimental condition. The use of a drying assembly consisting of multitiered vibrating screens produced better results than the rotary kiln and has definite possibilities of providing an effective means of drying coal fines in relatively large quantities.

Jan 1, 1973

The Engineering Societies Building is owned by the United Engineering Society which is composed of the American Institute of Mining and Metallurgical Engineers, the American Society of Civil Engineers, the American Society of Mechanical Engineers, and the American Institute of Electrical Engineers, the four national engineering societies known as the Founder Societies. Its erection, and that of the Engineers Club which adjoins, was made possible through the generosity of Mr. Andrew Carnegie, Honorary Member, who in 1903 contributed $1,500,000 for the purpose. The Founder Societies purchased the land on which the Engineering Societies Building stands and the Engineers Club the land for its building.

Jan 1, 1923

By J. F. Harvard

We might say that for the metallurgist time "ambles withal," for the mining engineer time "trots withal," and for the geologist, time "gallops withal." And anyone for whom time "stands still withal" does not belong in the mining community today! In this bicentennial year of the United States of America we sense the mystery of time and we feel the pulse of history, especially in our own profession. What was mining like 200 years ago? What is it like today? What will it be like 200 years in the future?

Jan 7, 1976

There are no data available of shipments until 1858, and then estimated, when railroad service became available. By reason of the iron made in the county, and the large amounts of salt, the tonnage used locally was quite large, and until 1860 these are estimated from the probable salt and iron production. After 1859 the tonnages shipped by rail are partly estimated from the total shipments of the Allegheny Valley Railroad from four counties. It is believed that the totals are below, rather than above, what the actual production was. While considerably larger for the same years than figures given by the Secretary of Internal Affairs and census reports, these data were always too low in those days, partly because of lack of facilities for gathering them, but more largely because of the strong prejudice existing in those days against furnishing such data to any governmental agencies.

Jan 1, 1942