Search Documents

By Lynton Gormely

Oxygen transfer in a stirred tank bioreactor has been modelled mathematically to determine the trends in transfer efficiency (kg transferred per kWh) with transfer rate, tank depth, superficial velocity, and mixer power.

Jan 1, 1990

The American Mining Congress International Coal Show, this year’s largest gathering of coal industry leaders, convened May 5-8 in Chicago. Against a 73 000-m2 backdrop of the coal industry’s most productive equipment,* some 23 000 people heard government and industry executives give guardedly optimistic reports of coal’s near future gains. Although a rocky road lies ahead, operators and suppliers still continue their search to improve efficiency. Among the ideas discussed at the show were better underground communications systems, continuous on-line coal analysis, and recovery of hard-to-float coal.

Jan 7, 1980

By Gerd Oberheuser, Hans Kellerwessel

Comminution with high compression roller mills finds rising interst in ore and minerals industry. Energy saving and upgrading of existing grinding facilities is one of the main reasons. Beside these possibilities other positive effects on the downstream units operations require also intense testwork. Basic interdependencies of the operational parameters gained at the testwork and their influence on the upscaling procedure are described.

Jan 1, 1995

By Michael Honerkamp, Clemens Mann

A quarry is not a static, but a dynamic structure that greatly affects the appearance of the surrounding area. Excellent planning is required today to cope with this continual change. In this paper several case studies are presented where computerized three-dimensional visualization has been successfully applied.

Jan 1, 1996

By Daniel P. Farjeat, Hector A. Canseco, Juan M. Schmitter

Since the early sixties, tunneling in the soft clay of Mexico City, has been done with the aid of open face shields and recently with compressed air. The use of pressurized shafts up to 1.5 kilograms per square centimeter, (147 kilo pascals) with vertical locks to launch the shields, have been used in two cases. After advancing almost 200 meters of tunnel, the same vertical locks were transformed into horizontal locks, to continue the work. Due to the high decompression times involved, it was necessary to install long locks, using the tunnel itself as part of the system. This article describes those cases.

Jan 1, 1981

A one-day seminar designed to help quarry and mining managers make their operations more productive, more efficient and less expensive was held in Harris- burg PA. "Rock-Solid Productivity" was sponsored by Pittsburgh Power & Light (PP&L). The seminar, one of a series sponsored by PP&L in 1997, proved to be well-organized and provided valuable information to the many quarry and mining professionals who attended. The information presented included a comparison of on-site diesel power vs. electric power, discussions of equipment improvements and topics on environmental management.

Jan 1, 1998

By J. Muir

This report focuses on minimum ore block sizes that are economically feasible to mine with the vertical crater retreat (VCR) method. In 1985, Homestake Mining Co. began a program to bring several small block VCR stopes on line. This report examines these experimental stopes, including design parameters, ground control, drill patterns, secondary blasting, and mucking. Cost and scheduling comparisons are made with mechanized cut-and-fill and open cut- and-fill methods.

Jan 1, 1987

By Jon Y. Kaneshiro, Blake D. Rothfuss, Gregory E. Korbin

A critical aspect of the planning, investigation, design, and construction of an underground excavation project is the portal. The portal is the primary access through which most if not all tunnel construction is carried out and it is the lifeline of the tunnel. Planning considerations include depth of cover, slope stability, economics of open cut versus shaft access, environmental impact, and contractor staging area. Critical aspects of planning, investigation, design, and construction of portals are considered by discussing portal design and portal failure case histories.

Jan 1, 1995

By Walter Shukin, Mark T. Olsen

An enormous quantity of tailings to be ultimately stored, unfavorable topography, severe climatic conditions, and an environmentally offensive red effluent all contributed to the challenge of designing an effective and cost efficient tailings confinement program at the open-pit iron ore mine operated by Quebec Cartier Mining Co. at Mount Wright in northeastern Quebec. The mine has been operating since 1976, but a detailed disposal plan was first initiated with construction of some channels and ditches during 1980. In the coming years, a system of dams, channels, and tailings confinement dikes will be constructed to accommodate tailings produced in the next 25 years. Careful consideration has been given to environmental effects, and the works under construction have been sized and situated to be extended as required to an ultimate mine life of 87 years.

Jan 8, 1981

By J. Iannicelli

A variety of domestic bauxites have been beneficiated to meet refractory grade standards by use of high intensity, high gradient, wet magnetic separation. Besides reducing the iron content to less than 2%, the Ti02 content of the bauxite was also reduced. The beneficiation can be accomplished by means of a simplified wet process flow sheet with an estimated cost comparable to that of water washed, filler grade kaolin. The process has been carried out on a small pilot plant and then scaled to produce 25 tonnes of calcined refractory bauxite meeting National Stockpile Specifications.

Jan 1, 1984

By Kenneth R. Dickson, I. Michael Gowring, Gary M. Davey

The Kemano Power Tunnel is currently being constructed by a joint venture of Atkinson, Kiewit, and Commonwealth. The 5.73 m diameter, 16.1 km long tunnel is part of the Kemano Completion Project in British Columbia, Canada which is being developed by Alcan Smelters and Chemicals Limited. The discussion includes the refurbishment and development of Robbins TBM 189-229 previously used at Calaveras (RETC Proceedings, 1987), the logistics of conducting a tunneling operation in a remote area with adverse weather conditions, in addition to a description of the work and the performance details in the various geological conditions encountered to date.

Jan 1, 1991

By J. Partyka

Fumes produced during blasting operations in underground mines are defined in this paper by an equivalent contaminant source. The primary goal is to establish a method which would allow all those parameters not measured directly to be determined reliably from field data. The parameters to be identified are the diffusion coefficient , and the position and size of an equivalent source. The diffusion-value is computed from the peak concentrations taken by two monitors located in the drift. The first monitor is placed close to where blasting pollutants join the main stream, while a second monitors is moved downstream a some distance from the first point. The position and size of the dust source and the total amount of dust produced during blasting are determined from the data recorded by only one monitor.

Jan 1, 1991

One of the most challenging and ambitious dump rehabilitation projects in South Africa’s mining industry is being carried out at Greenside Colliery’s smoldering coal dump, which lies adjacent to the N 12 Johannesburg-Witbank highway. Greenside Colliery is the largest coal mine in the Gold Fields Group. It began operation in 1946, the year in which the burning dump had its origins. Today, Gold Fields plans to spend R16 million (about $USS8 million) to encapsulate the dump, bringing it into compliance with South Africa’s Mining Environmental Management Programme, according to Martin Hamer, engineering manager of the Greenside Colliery. The improved environmental management approach will result in reduced sulfur dioxide gas, smoke and dust emisson into the air and an enhanced aesthetic appearance of the dump from the N 12 highway. The objectives of the project are to place and compact coal discard to within the National Institute of Coal Research specifications in order to prevent spontaneous combustion, and to preserve as an asset the coal portion of the discard.

Jan 1, 1994

By Marietta Canty

Results are presented that were gathered during field-scale testing of an innovative technology, sulfate-reducing bacteria (SRB), designed to treat and control acid mine drainage (AMD). The project was performed under the Mine Waste Technology Program (MWTP), which is funded by the U.S. Environmental Protection Agency (EPA) and jointly administered by the EPA and the U.S. Department of Energy through an Interagency Agreement. The MWTP is implemented by MSE Technology Applications, Inc., located in Butte, Montana. A field-scale test is described in which the subsurface workings of an abandoned mine were used as an "in situ biological reactor."

Jan 1, 2000

By C. F. Lee, Bezalel C. Haimson

A 300 m deep test hole at Ontario Hydro's Darlington nuclear plant site, 65 km east of Toronto, was used to determine the state of stress in the Paleozoic limestones (O-22O m depth) and the Precambrian granitic gneiss (220-300 m). The results of the hydrofracturing measurements indicated a state of high horizontal stress along the depth of boring and a consistent orientation of principal stresses in each geologic unit. These results were confirmed by a borehole TV camera survey, and by overcoring tests. The magnitudes and orientations of the measured in situ stresses were used in a feasibility study of siting an underground nuclear plant, and in particular in the geotechnical design of proposed reactor caverns in Precambrian rocks. Their implications on cavern stability under operational and accident conditions were analytically studied, taking into consideration the potential superposition of thermomechanical stresses under loss-of-coolant condition, and the possibility of thermal spalling in the host rock.

Jan 1, 1979

By William B. Thayer, James H. Meinholz

The Milwaukee Metropolitan Sewerage District (MMSD) has been working since mid-1977 on a fast track to meet a court-imposed schedule to rehabilitate a large wastewater collection and treatment system at an estimated cost of $1.7 billion. Because of glaciation, the Milwaukee area has an extremely complex geologic environment. The rock surface ranges from outcroppings in the northern and western parts of the area to 76 m (250 ft) below the surface at the mouth of the Milwaukee and Menomonee Rivers. Bedrock beneath the glacial mantle is a thick sequence of early to middle Paleozoic sedimentary rock. To cope with the many complexities of this large public works project, a Program Management Office (PMO) concept has been employed. A Geotechnical Engineering Group was established within the PMO to provide a continuous , unified approach to geotechnical engineering and full disclosure of all geotechnical information in the construction contract documents. It provides qeotechnical engineering to design and construction, develops and maintains a qeotechnical data base, and participates on the claims resource team.

Jan 1, 1983

By James P. Dorian

Like Russia and Ukraine, Kazakhstan is one of a few former Soviet republics well-endowed in mineral and energy resources (Fig. 1). Kazakhstan is the second largest newly independent Commonwealth state. It possesses major fuel and power centers, including 20 electric power facilities that operate on the more than 300 kt (330,000 st) of coal extracted daily. These power stations supply Central Asia, the Urals and Western Siberia with much needed electricity. Kazakhstan plays a critical role in Central Asia as it serves as both the regions' economic and political hubs. While Kazakhstan already contains a robust and diversified minerals industry, the government is actively pursuing foreign investment to boost production capacity and improve efficiencies in operations. A primary objective of the Kazak government is the expansion of metal processing facilities to improve the country's long-term export potential. Since 1991, international mining companies have found the investment climate of Kazakhstan relatively favorable. This is due to tremendous efforts by government officials to create sufficient investment legislation and a national minerals policy, while eliminating bureaucratic bottlenecks common to most other former Soviet republics.

Jan 1, 1993

By Steve Kral

The success of the industrial minerals end of the mining industry is often overshadowed by the high price of copper, the glamour of gold, and the nation's huge reserves of coal. Those three segments of the industry, however, along with every other business in the world, could not function without the products that are composed of a variety of industrial minerals. And, according to Haydn H. Murray, past president of SME, the value of industrial minerals in the United States is more than triple that of metals, about $19 billion a year versus $6 billion. In the developed countries of the world, he said, the value of industrial minerals is nearly always greater than the value of metallic minerals. Murray, also a professor of geology at Indiana University, was the luncheon speaker at the SME-sponsored Grinding of Industrial Minerals conference held in Asheville, NC this past September. Producers of industrial minerals know they must squeeze the maximum value out of the industrial mineral being mined and processed, Murray told the audience of about 100 people. Grinding and particle size, then, are vital to a commodity's profitability.

Jan 1, 1990

By Thomas D. Kaufmann

The 1982 recession set the US mining and metals industries reeling. Will the oncoming recession of 1991 hit as hard? Probably not, thanks to a shallower downturn, a weaker dollar and remarkable lower costs. Effects of the last recession That the 1982 recession was traumatic to the American mining and metals industry is an understatement. Quantities of metals consumed dropped. Metals prices fell despite continuing general inflation. The resulting real gross revenues of producers of each of the major metals plunged, in the trough of 1982, to levels one-fourth to two-thirds of those of the peak of 1979 (Table 1). By contrast, most industries in the United States were not hit anywhere nearly as hard. Real GNP, the aggregate of all production, slipped only 1 % from 1979 to 1982. Metals are most sensitive to the business cycle because of their applications. All metals but gold are raw materials to downstream industries. Raw materials are victims of strong fluctuations. This is because buying industries try to hold high inventories in boom periods when goods are in short supply. They reduce inventory levels in buyers markets when suppliers have idle capacity and raw materials are in ample supply.

Jan 1, 1990

By Ernest L. Ohle

Since the first recorded discovery of lead in southeast Missouri near Fredericktown about 1720, knowledge of the deposits has advanced in spurts as a result of outlying discoveries: 1864 Bonne Terre 1890 Flat River, Desloge, Leadwood 1948 Indian Creek 1955 Viburnum The original discoveries at Bonne Terre consisted of residual galena in clay, similar to that in the previous finds at Fredericktown. Occurrences in solid dolomite were not noted until mining of the clay pits exposed the walls of the weathered depressions. The St. Joseph Lead Co. had been established to conduct the operations and it was J. Wyman Jones, first president of St. Joe, who at that time brought about the first of the technological advances that were to occur in the district. He proposed use of the newly invented diamond drill to explore the bedrock showings, after observing the machines in the Vermont Marble Belt.

Jan 1, 1991