Search Documents

By J. Nolan, B. Ande’n, E. Lindgren

Field testing was conducted at the Strassa Iron Ore Processing Plant to evaluate high-gradient magnetic recovery of iron from the plant's tailings. The installation is the first commercial application of the Sala Continuous High-Gradient Magnetic Separator (HGMS) Model 480 Carousel. The objectives of the five-month testing program included optimization of the operating parameters using SSDEVOP techniques to maximize iron recovery, along with establishing a long-term operating history for the SALA 480 HGMS Carousel. The effectiveness of the optimization procedure, the net benefit in term of iron recovery, and equipment performance are discussed in the paper.

Jan 1, 1983

By Kichizo Niwa, Toshio Yokokawa, Mitsuo Shimoji, Yoshihiko Watanabe, Satoshi Kado

A LTHOUGH a systematic research on diffusion in liquid metals has not been carried out, partial studies have been developed by various workers in several systems. A few recent papers among them have shown that this line of approach is quite useful for understanding the structure of the liquid state. Furthermore, it has been found in kinetic

Jan 1, 1958

By S. A. Ford

A SHORT and accurate method for the estimation of manganese in iron and steel is of great advantage to Bessemer works, and I think it may be of interest to some of the members of the Institute to give in detail the process in use in the laboratory of the Edgar Thomson steel works. The process is based on the reaction first described by Beilstein and Jawein.* The steel, spiegel, or iron is dissolved in strong nitric acid, sp. gr. 1.½. Evaporation to dryness is not necessary, unless the amount of silicon is large, as in the case of certain pig irons. Then, as a clogging of the filter in the subsequent filtration is apt to follow, dissolve first in a dish in hydochloric acid, quickly evaporate to dryness, redissolve in the strong nitric acid, boil, and while boiling throw in crystals of chlorate of potash from time to time. Violent action ensues, yellow fumes are given off, and binoxide of manganese is precipitated, since it is insoluble in strong

Jan 1, 1881

By D. W. Kestner

Recent developments and trends in the state of the art as being commercially applied to the pelletizing and sintering of metallic ores, concentrates and reverts will be reviewed. Both ferrous and non-ferrous materials will be covered. The influence of environmental considerations on the decision to build, the process selection, and design of the plants will be discussed. Use of coal in iron ore pellet induration will also be reviewed as the availability and price structure of oil and gas becomes a consideration to the plant operators.

Jan 1, 1980

The Institute conducts jointly with the American Society of Civil Engineers, American Society of Mechanical Engineers and American Institute of Electrical Engineers, certain activities as listed below, and is joint owner with them of certain properties. United Engineering Trustees, Inc. When Mr. Carnegie made his gift which made possible a home for the engineering societies, a separate corporation was organized to act as a holding company and to manage the common property. This was long known as the United Engineering Society, but the name has 'now been changed to one which more nearly reflects the real function of the corporation. It holds title to the Engineering Societies Building and to various funds placed in its charge and is managed by a Board of Trustees, of which three are chosen by each of the four societies, American Institute of Mining and Metallurgical Engineers, American Society of Mechanical Engineers, American Institute

Jan 1, 1934

New Device Eliminates Blasting in Coal A non-explosive device developed by duPont utilizes the high pressure of a gas generated inside a steel tube which is inserted in a hole drilled in a coal seam to break down the face of coal. Chemical reaction is started by an electric current which produces heat to initiate the action. The same heat destroys the starter wire as soon as electric current is no longer needed. The tube containing the chemical is closed at the outer end by a plug with electrical connections, and at the other with a disk that is ruptured by the compressed gases formed. When the gas has been liberated in sufficient quantities to create a desired pressure the disk breaks and the released gas breaks down the coal face. The new device is called a Chemechol.

Jan 10, 1951

By George B. Holderer

The relation between man-hours of labor and production may be correlated for any industry, and already it has been widely used in piecework studies. It is not in general use as yet for recording labor efficiency of an enterprise or an industry. An exception to this is the Cement Institute, which tabulates the man-hours used in each operation and thus gets the total man-hours per barrel of cement. The writer knows of one steel company that keeps a complete record of man-hours for every operation from mining the ore to finishing the product. No doubt many others find the information useful, and such a study could be of value to the mineral industries.

Jan 1, 1937

By Oliver Bowles

WHEN a new type of equipment revolutionizes methods of quarrying one kind of stone, producers of other kinds focus their attention on its potentialities in their particular fields. The purpose of this paper is to discuss the accomplishments of the wire saw in slate, to show its more limited attainments in other kinds of stone, and to point out the possibili-ties of much wider application. A wire saw consists of a 3/16-in. or 1/4-in. three-strand wire cable that runs as a belt and cuts the rock by abrasion. (Fig. 1.) The teeth of the saw are sand grains carried in the grooves between the strands.

Jan 1, 1936

By T. F. Petty

During 1935 there were drilled in North Central Texas 1071 wells, of which 565 were dry holes, 469 were oil wells with an initial production of 43,766 bbl. and 37 were gas wells with an initial production of 129,332,000 cu. ft. Production has been 14,180,042 bbl., or a daily average of 38,849 bbl. In Table 1 are listed the various pools of the district. Most of the smaller pools are of minor importance and are merely productive spots. Numerous other similar spots might have been listed as pools but their production is included in other fields. There are a few flowing wells but practically all of the wells are being pumped. The estimated potential is about 50,000 bbl. and the allowable production is based on the Texas Marginal Well Law. In Table 2, wildcat wells that have resulted in the discovery of pools or important extensions to old pools or that have contributed to the geological information of the area are listed.

Jan 1, 1936

By R. W. Leonard

A method of accurately determining the value of gold-bearing ores and gravels with a compact field-outfit is much desired by prospectors, especially when the work lies in a district far removed from railways or good wagon-roads. We are all familiar with the fire-assay of gold-ores, and fully recognize its accuracy and value; but only those who have tried to determine the value of a gold-bearing vein as a commercial venture, from fire-assays of selected samples, know how misleading is the information thus obtained, however carefully and honestly the samples may be selected. The reasons are that, for the fire-assay a very small portion of ore is treated (rarely more than six assay-tons, or a little over one-third of a pound), and a minute particle of the precious

Jan 1, 1896

By J. N. Munro

At the present stage of geothermal technology and the still limited applications of geothermal energy, most of us consider any use of "things geothermal" to be something out of the ordinary. If in such a situation there can be a use of geothermal energy which is even more unusual, then the utilization of geothermal energy-or more precisely, geothermal heat--for the manufacture of salt is just such a use. This is the essence of investigations in the Fiji Islands, where experiments in the evaporation of seawater to product, salt have been conducted using geothermal heat emanating from the ground in an area of hot springs. The hot springs are located on the coast at Savusavu in a depression about GO ft wide. There are ten individual springs, but most of these are small and insignificant. The temperature of the water from these springs reaches 100°C.

Jan 9, 1964

By Lawrence W. Teufel

An anelastic strain recovery technique is presented as a method of determining the directions and ratio of the maximum and minimum horizontal in-situ stresses from oriented cores from deep wells. Predictions of hydraulic fracture azimuth inferred from principal stress directions determined from both elastic and time-dependent (anelastic) strain relaxation measurements of volcanic tuff are consistent with the observed orientations of hydraulic fractures produced in simulation and mineback experiments, underground at the Nevada Test Site. In addition, anelastic strain recovery measurements on oriented cores of shale and sandstone from well depths of about 1680 meters show consistent relaxation directions of the principal horizontal strains and have enabled a prediction of the principal horizontal stress directions and hydraulic fracture azimuth.

Jan 1, 1982

By W. M. Rust, W. D. Mounce

THE almost universal acceptance of electrical logging by the petroleum industry calls for a critical examination of the physical bases of the common methods. This is particularly needed for the natural potential log. The conventional explanations are based on the phenomena of electrofiltration and electro-osmosis. However, experimental data show that they fail to give a basis that is quantitatively sound. Moreover, they lead to interpretations of details of electrical logs that are erroneous. It was found experimentally that when a plug of shale is placed in a chain of dissimilar electrolytes, a current flow results. Experiments on oil-well cores and fluids similar to those existing in wells show that potentials are set up which are in reasonable agreement with those encountered in electrical logging. Doubt- less other sources of potential are important but this explanation not only accounts for much of the potential but also clarifies some fairly familiar examples of misinterpretations.

Jan 1, 1944

By R. E. Mazurak, E. L. Ealy

At the Beckley mine in southern West Virginia, forecasting unstable roof conditions in advance of mining is accomplished by wing a rating system that combines historical information on mine roof failures with known mine geology. Failure frequency rates are derived for each category of roof rock composition, unit thickness, structure, and extraction ratio. In this manner, known geological environments are rated according to instability based on actual experience. Drill hole control and geological interpretation provide the basis for forecasting unstable conditions beyond working faces. The forecasting technique has assisted mine management in reducing fall frequencies by 80% over the past two years compared to the first five years of operation. This reduction in fall frequency was accomplished by modifying the plan of advancing sections to minimize mining exposure to unstable roof conditions.

Jan 1, 1983

By Fred D. DeVaney

Probably no ferrous metallurgical process has ever found such ready acceptance and rapid expansion as the pelletizing of iron ores. The process was first commercialized in the early 1950's and since then it has grown to the point where the amount of material pelletized worldwide will approach 100 million tons in 1971. The term agglomeration is used to describe any process by which fine material is formed into larger shapes or agglomerates and includes, in addition to pelletizing, such processes as sintering and briquetting. Sintering cannot be used to efficiently agglomerate iron materials containing a high percentage of 100-mesh fines but the method has been widely used over many decades for agglomerating flue dust, mill scale and iron ore finer than 3/8 in.

Jan 1, 1971

One Hundred Sixteenth Meeting of the Institute, Monday, Feb. 18, to Thursday, Feb. 21, inclusive, 1918 A preliminary program, for the New York Meeting was printed in the January Bulletin, and a more detailed program was mailed to all members early in January. The following schedule is the outcome, of sundry committee meetings up to the middle of January. Committee on Arrangements J.` E. JOHNSON, JR., Chairman BRADLEY STOUGHTON, Vice-Chairman RALPH W. DEACON MRS. S. J. JENNINGS E. M. SHIPP J. V. N. DOER A. R. LEDOUX G. D. VAN ARSDALE L. `V. FRANCIS . . F. T. RUBIDGE ARTHUR L. WALKER Summarized Program MONDAY, FEBRUARY 18 9 a. m. to 5. p. m. Registration at Institute Headquarters. 10 a. m. Sessions on Coal and Non-Ferrous Metallurgy. 12.30 p. m. Luncheon at Engineering Societies'. Building. 2 p. m. Visit to Subway Workings.

Jan 2, 1918

By Lawrence Dykers

The paper presents a generalized history of the growth and utilization of electronic data processing in a medium- size, mining-oriented company. A brief narrative outlines a corporate wide data gathering system, its hardware and application. Responsibility areas for corporate accounting, operations control, engineering, and research program development are defined. A Synopsis of programs within responsibility areas is presented along with a review of program language requirements for each of these areas. Anticipated additional uses of computers and the programs being developed for these uses are outlined. The scope and growth of an Information Systems Department within Duval Corporation is briefly discussed. Suggestions are presented which should help minimize the problems and avoid some of the pitfalls of program development for those contemplating the initiation or revision of an electronic data processing system. The importance of lucid and comprehensive program documentation is stressed.

Jan 1, 1969

By Frank L. Bazzanella, Paul A. Weyler

A brief introduction to gravity concentration is presented, including some discussion on the more common minerals currently recovered. The important considerations in basic design of a gravity plant are mentioned and four currently operating flowsheets are presented. The plants discussed in detail include the Climax Molybdenum Co. By-Product Plant and the Canada Tungsten Ltd. Plant. Plants briefly highlighted include the Palabora Mining Co. Uranium Recovery Facility and the Bridge Hill Ridge Heavy Mineral Recovery Plant of Mineral Deposits Ltd.

Jan 1, 1978

The old single-jack may have been portable- but it left much to be desired in drilling speed and depth of hole. Portable compressors for drilling can be snaked into tough spots. However, that calls for more men, equipment, and money, with corresponding loss of mobility. The drills listed in this notebook sheet meet three requirements: They are light. They are self-powered. And all are reported proven in practice. Undoubtedly there are other units filling the requirements that are not listed. Extreme mobility for far-flung exploration teams is always an acute need. The drills listed here help solve the problem. Canadian Longyear, for instance, reports that the Porta drill has been parachuted into wilderness spots and helicopters have lofted light core drills onto mesa tops in the Colorado Plateau uranium country.

Jul 1, 1955

By W. G. Fischer

This paper attempts to close the gap between extensive rock testing with field measurements and the mine operator's need for safe mine layouts and alternatives. It was found that many of the variables that influence mine geometry and worker safety are relatively unimportant while others are critical. The development of empirical relationships that tie the critical variables to the safe useful life of a trona mine layout and observations made in 140 production areas where the variables were researched over a 15-year period are discussed. The concepts presented may have applicability in mine design for other bedded deposits.

Jan 1, 1986