Search Documents

Jan 1, 1923

c

Jan 1, 1918

INTRODUCTION The difference between a mineral inventory or mineral reserve and an ore reserve was discussed in the introduction to Chapter 10. The term ore reserve implied mineral in place that is capable of being mined at a profit. Potential profitability of in situ minerals is dependent upon several economic parameters in addition to grade estimates for blocks of the mineral

Jan 1, 1980

By J. C. Smock

THE magnetic and polaric properties of magnetite, or magnetic iron ore, are fundamental facts in magnetism. The disturbing effect of this mineral upon the magnetic needle in land surveying must have been very early observed. The difficulties arising from this source are still almost insurmountable in making accurate surveys in districts where this ore occurs to any extent, either as a rock

Jan 1, 1876

By S. J. Shale

Recent changes at Cornwall are highlighted by development of a panel caving method, with slushing drifts, for underground practice as open pit operation nears close. Metallurgy keeps the pace with high recovery from increasing amounts of harder to liberate, higher sulphide content, underground ore.

Jan 7, 1953

New York Meets first Wednesday after first Tuesday of each month. DAVID H. BROWNE, Chairman. PERCY E. BARBOUR, Vice-Chairman. A. D. BEERS. Secretary, 55 Wall St., New York. N. Y. C. A. BOHN, Treasurer. Boston Meets first Monday of each winter month. C. C. EUSTIS, Chairman. R. L. AGASSIZ, Vice-Chairman. E. E. BUGBEE, Secretary-Treasurer, Mass. Inst. of Technology, Boston, Mass. ALBERT SAUVEUR, H. L. SMYTH. Columbia Holds four sessions during year. Annual meeting in September or October. STANLY A. EASTON, Chairman. FREDERIC KEFFER, Vice-Chairman. LYNDON K. ARMSTRONG, Secretary-Treasurer, P. O. Drawer 2164, Spokane, Wash. C. LIVINGSTON. FRANK A. ROSS.

Jan 6, 1916

By Robert W. Hunt

There are certain physical characteristics of steel resulting from its treatment while being formed into useful products which have been, and are, well known to its manipulators ; but under the stress of business competition and other controlling influences, all knowledge is not always given either full sway, or even full acknowledgment. Such has been the case in the making of steel rails. It is universally acknowledged that steel rails of heavy sections, made during the last tell years, have not given as good service as the rails of lighter sections produced before that time. While certain fundamental principles of steel-making have been acknowledged, their application to the steel-rail manufacture has been, if not actually denied, completely ignored.

Jan 1, 1902

By L. A. Pursell

Environmental constraints can both delay and raise the cost of a major plant addition, often requiring a complete reevaluation of the plant site and the proposed project. In this case history, steps are presented which were followed in applying for environmental permits for a major addition to a lime plant. Methods are described for determining expected emission increases and for selecting the best control technology for each source. The description progresses through pre-application conferences with control agencies, the formal application procedure, computer modeling the air quality impact, and the methods followed in obtaining a favorable determination.

Jan 1, 1983

By Edna A. Dancy

Jan 1, 1965

Jan 1, 1915

By Peter M. Grant

The paper describes in broad outline the design of circular shaft linings with particular reference to the practical aspects. In the main it refers to recent British and German practice but has general application for any shaft lining design.

Jan 1, 1983

By Tennyson Smith

Jan 1, 1962

By B. Y. Ekber, A. S. Gorbachev

The development of economically effective and safe methods of mining thick coal seams allow considerable coal reserves to be used as an energy resource all over the world.

Jan 1, 1979

By F. G. Loper

Simulation as a mathematical technique is not new. However, recent increases in digital computer speeds and the ease of programming with languages such as Fortran have centered a good deal of attention around simulation in the last few years. By ignoring all but the relevant characteristics of a process, a mathematical simulator may be constructed which, when fed operating data, should react as the process would. The output becomes numbers, instead of tons, however. Thus, a trial-and-error operation of such a simulator will permit management to study a major system change at little cost.

Jan 1, 1967

[ ]

Jan 1, 1938

Jan 1, 1911

By B. S. Taylor, J. D. Fraser, W. L. Chen

Steam coal quality is less stringent than metallurgical coal quality. Steam coal is prepared either by cleaning a full-size range of raw coal or cleaning coarse coal only, leaving the fine coal raw. The latter scheme is more cost competitive. It is particularly applicable to US eastern soft coal where low ash coal is concentrated in fine sizes. For raw coal size separation the Rotating Probability Screen, developed by the British Coal Board, may be used for easy change of raw coal separating size, and to avoid screen deck plugging when handling wet and clayey raw coals.

Jan 1, 1985

By William P. Blake

The phenomena of concentric arrangement of minerals in rock-masses, generally known as " orbicular structure," have of late received much attention from investigators. Lawson, of the University of California,' has described the orbicular gabbro at Dehesa, San Diego county, Cal. Kessler and Hamilton, of Stanford University, working independently upon the same subject, published their descriptions,2 giving also a list of many other localities in Europe and America where orbicular rocks are found, adding copious references to the literature of the subject.

Jan 1, 1906

By Reynold Q. Shotts

Data are presented which show that fractions of varying densities from the same coals are oxidized at different rates by nitric acid. From oxidation data, the approximate quantity of "bright" and "dull" components may be calculated. Definite relationships between oxidation rate and rank are shown for density fractions from at least two bituminous coals.

Jan 8, 1950

By Frank T. Weems

The basic operating properties of the DorrClone are discussed and certain metallurgical applications which exploit these properties are presented. An effective method of controlling the consistency of the DorrClone underflow is described.

Jan 8, 1951