Search Documents

By K Whelan

The Land Access Branch of the Mines Division of the Northern Territory Department of Mines and Energy is responsible for Aboriginal Liaison and cross-cultural matters that affect the Department. In essence, it exists to provide a basis for communication between the Department, industry. Aboriginal organisations and Traditional Owners. The paper outlines the various ways in which this is accomplished including the preparation of detriment submissions for pending land claim hearings, the use of promotional material to support access to Aboriginal Land for NTGS Mapping Programs and field work, and advice/assistance on exploration and mining issues.

Jan 1, 1994

It is well known that in most areas of Central Europe it is not difficult to find water - usually at shallow depths - and to recover and use this water. What is much more difficult, however, is to find water sources that offer both sufficient in quantity and qual- ity. Far too often, there are sources that offer abundant quantities but of poor quality or vice versa, i.e. high quality water but insufficient volumes. In the former case where water quality is not adequate - which is more often than not due to anthropogenic factors and only very rarely a result of geogenic effects - the application of treatment techniques can help to turn such water into potable water that is suitable for human con sumption.

Jan 1, 1988

The blasting of the 2190_6095 stope at Kimberley Nickel MineÆs Sally Malay operation in Western Australia is an example of what can be achieved with electronic detonating systems when a drill and blast engineering team is faced with complex blast geometry and a major pump station in close proximity to the stope. Using Dyno NobelÆs HotShotÖ system, the engineering team successfully designed and initiated the 36.5 Kt stope firing, with a powder factor of 0.35, resulting in no damage to the pump infrastructure, better fragmentation of the ore and less overbreak in what had previously been a geotechnical and geometrically challenging stoping environment. This paper will discuss the design parameters used for this stope blast as well as the benefits the operation found in using precision detonator timing in this 252 hole shot over two levels using a combination of up and down and slashing rings that were initiated in four different directions.

Jan 1, 2007

By Bell MG

At various decision points in the development of a project, a developer, joint venture partner or financial institution may require an independent review of the basic assumptions and technical aspects of the project. This type of review or technical audit is becoming a more common feature of the project development process. This feature has evolved because of the need of investors and lenders to be more confident of the viability of a project by the confirmation of its technical and cost aspects. Technical Audits offset some uncertainties introduced by the combination of longer development periods for, projects and the highly dynamic world economic scene. This paper reviews the place, nature and process of the technical audit by examining the circumstances when it might be needed, the typical scope of work or brief, the responsibilities of and relationship between the auditor and the client, and the auditing procedure. Detailed aspects of technical audits are discussed followed by a case study of the Hail Creek Coal Project Audit.

Jan 1, 1983

The mining industry represents a small part of the international economy. Comprising few large companies, the industry exhibits volatile returns and over the past 25 years has failed to produce a long-term return that meets its cost of capital. It is not surprising, therefore, that the minerals extraction and processing industry is under considerable pressure from the investment community to lift its game. Management and boards are responding to this pressure by implementing more exacting cost control measures, capital management programs and through the process of consolidation. However, the cost of capital to the industry appears to have increased in recent years and investor attention seems to be preoccupied with the ænewÆ economy. Both of these influences will conspire to raise the bar for acceptable industry economic performance. This paper provides a useful snapshot of the minerals and extraction industry as it enters the 21st century. It remains cautious about future performance other than to conclude that single digit returns are likely to prevail, albeit at higher levels than over the past 25 years.

Jan 1, 2000

By W A. Tchernykh, R P. Strelnikova

In connection with the fact that technology of ore mining by caving system is often used when mining of deposits, characterising by low stability of surrounding rock mass, the main problem for such ore mines is ensuring stability of mine workings, placing in a zone of influence of winning operations. Besides natural disturbance of ore mass, stability of workings depends on the dynamic effect of blasting operations and also on the dynamic effect of structural blocks detaching from the ore mass and colliding with crests of ore pillars in the bottom of a chamber. Decreasing of dynamic stresses may be achieved by way of creation of a compliant porous screen or an ore cushion in the chamber bottom. It is established that maximum levels of compression take place when the first impact impulse occurs, and after that increase of compression of protective slice decreases. Necessary thickness of screen slice was substantiated theoretically with due account of height of structural blocksÆ fall, their mass, deformation modulus of ore mass and ore cushion.

Jan 1, 2003

By S Williams

The primary objective of most mining projects is to maximise the value delivered to the companyÆs shareholders. Achieving best practice performance and maintaining competitive advantage through low-cost production and high productivity is essential to achieving this aim. Benchmarking is an essential tool for the identification and implementation of best practice performance, and to realise continuous improvement by ensuring best practice becomes common practice. But to be successful, that is to deliver long-term value creation, benchmarking must be holistic and align operational performance with strategic intent. This paper outlines a rigorous and structured approach on how to conduct a successful benchmarking program that aligns operational performance with the businessÆs goals. Further it investigates the benefits that benchmarking can provide throughout the project life cycle and provides some key learnings from some of the worldÆs leading miners.

Jan 1, 2009

A company tax rate based on profitability return, or as more commonly expressed, a resource rent taxation scheme has been intro- duced at various stages in the past by both Australian state and commonwealth governments. At present a number of overseas countries are applying this form of legislation to the taxing of sections of their mining industries. Within this study, ways in which this type of tax has been used are examined. The form in which the tax can be applied varies. 1. It can be selectively or universally applied. 2. The base on which economic return is calculated can be selected in a number of ways. 3. It can start operating only when high profit levels exist, or alternatively be the basis of a total taxation scheme. The implication for the Australian mining industry of the introduction of different types of resource rent taxation schemes is assessed within the context of previously enacted systems.

Jan 1, 1978

Roasting of zinc concentrate at the Risdon Works of the Electrolytic Zinc Company of Australasia Limited, (E.Z.), is carried out in two fluid bed roasters capable of treating 450000 tonne/yr, or sufficient for the output of 220000 tonne of salable zinc. The furnaces were constructed by Lurgi, Australia, to the basic design developed by Vieille Montagne Company of Balen, Belgium. The advantages of fluid bed roasting include a higher metallurgical efficiency in sulphur oxidation from a feed which does not require any pre-grinding, mechanical reliabil- ity through the absence of any moving parts within the furnace and the capability of being scaled up to a large unit.

Jan 1, 1977

To counter depressed world nickel prices, a continuing effort is being made at Kalgoorlie Nickel Smelter to reduce unit production costs. One major area in which production costs can be reduced is the substitution of coal for fuel oil. Two areas where this has been achieved to bring about a saving are, the addition of coal to flash furnace flux to reduce supplementary fuel oil requirements in flash smelting and the replacement of two oil-fired air preheaters with a coal-fired unit. These actions have resulted in coal replacing 67% of the current fuel oil requirement in flash smelting at the Kalgoorlie .Lckel Smelter.

Jan 1, 1987

In order to realise seafloor massive sulfide (SMS) mining, the environmental baseline survey around targeted SMS mining areas and the creation of an environmental assessment technique suitable for quantifying the impacts of ocean floor mining are necessary. The targeted areas generally host large chemosynthetic communities in association with active hydrothermal venting. The ecosystem structure around the chemosynthetic communities has not been clarified yet in macro-scale or quantitatively. The systematic approach and plan for the baseline survey and the environmental assessmentÆs basic studies are introduced. An EXTENDED ABSTRACT is available for download. A full-length paper was not prepared for this presentation.

Jan 1, 2008

By Hohnen CA, Limerick JM, Hall DRT

An uniquely-designed flash furnace for smelting of nickel concentrate and for the recovering of metal values from the slag generated has been in successful use for nearly six years. Within the last eighteen months the ability of the furnace to treat slag arising from converting operations without significant reduction in capacity has also been successfully demonstrated. Previously, converter slag had been treated separately in an electric furnace. The salient features of smelter developments are outlined and slag chemistry is discussed. The low cost method for the introduction of coal to partially replace light fuel oil is reviewed and total energy requirements evaluated.

Jan 1, 1984

By Stubbs B

In conjunction with Charles Copeman, we have arranged the presentation of a paper by Charles with a support paper by myself presenting alternatives to currentaccepted legal concepts involving the ownership of minerals by the Crown and the absence of ownership in any minerals or entitlement to benefit therefrom by the owner of the land on or under which the minerals occur.2. The current situation has its historical route in the concept of gold and silver being royal metals and belonging wherever situated in the Kingdom to the King and it is submitted it can be'seen as being archaic in nature perhaps even feudal and perhaps worthy in this day and age of reconsideration.Our purpose in these papers is to present an alternative view supported by argument challenging the present system and hopefully, creating room for comment and interchange amongst those involved in the industry. My solutions are not Charles Copeman's solutions and vice-versa. However, we do share a common belief that the present system may not be the best system.

Jan 1, 1990

Your Worship the Mayor, Ron McCullough; the Honourable Tony McGrady M.L.A., Minister for Minerals & Energy; distinguished guests, ladies and gentlemen.It's both a pleasure and a privilege to have been invited by the North West Queensland branch of the AusIMM to speak at a forum in Mount Isa to discuss the potential, and more importantly, the development of the great North West. I spent 25 years of my life proudly living and working in this part of the world, marvelling at its riches, exploring its potential, assisting in its development and responding to its challenges.As President of the North West Queensland branch of the AusIMM in the early 1970's I can clearly recall helping to organize a major symposium extolling the geological potential of the region, revealing the extensions of the Mount Isa copper orebody at depth and describing the potential of the then untapped Hilton Mine. Our optimism in the North West so obviously reflected two decades ago remains today.

Jan 1, 1993

By Harrison J

The correct selection of equipment to use in a mine is a problem which constantly faces the mining engineer. In some cases a wide choice of equipment with different operating characteristics is available. If this equipment is to be used to assist in moving the ore it may be possible to build a computer simulation model to predict how it will perform. Typical problems that lend themselves to this type of analysis are presented. The computer models are constructed using a recent form of the GPSS computer language, namely GPSS/PC for the personal computer. This language allows the programmer to construct models in a very short time and at a low cost. Of great importance is the easy way in which it is possible to change the models to answer any of the "what if?" questions the engineer may pose.

Jan 1, 1987

By L Crew, S Jackson

A trial of an Adept Online Ore Sizer (OOS) was undertaken at the WMC Leinster Nickel Operation (LNO) in the first half of 2000. During this time the On Line Ore Sizer has been shown to be a robust and accurate instrument for measuring mill feed ore size. Data collected during the trial indicates significant variation in the F80 of the SAG mill feed. The effects of feed size on milling parameters such as mill weight, mill power draw and mill efficiency appears to be dependent on the ore blend treated. With some ore blends a weak positive correlation was found between ore size and mill weight and milling efficiency but with others no correlation is evident. It is believed that the OOS will become a vital piece of equipment in the future as LNO continues to optimises its milling circuit.

Jan 1, 2000

By Swanson AR, Nicol SK

A study has been made into the influence of feed size distribution on the flotation response of coal. The results show that a full description of the flotation response of a coal must not only consider the inherent floatability of the coal, but also, the size distribution of the feed to flotation. The performances of a number of flotation circuits were compared using a coal which was "poorly floating" because of its size distribution. Split feed flotation, two stage reagent addition, and reflotation of classified tailings all gave better yields than that obtained by conventional single stage flotation. The optimum flotation circuit for the washing of the coal in question, was reflotation of classified tailings.

Jan 1, 1978

With the proclamation of the Environmental Protection Act, 1971-80, the Environmental Protection Authority and Department of Conser- vation and Environment were established to enhance the quality of the environment. Proposed gold developments of all scales can be referred to the Authority in the form of a Notice of Intent. Environmentally significant projects might then require preparation of an Environmental Review and Management Programme. Current environmental issues include the'effects of clearing by prospectors,, mine dewatering and tailings disposal. INTRODUCTION In the past, the environmental aspects of gold industry related activities have received little attention. However, with the proclamation of the Environmental Protection Act, 1971-80, mechanisms were instituted which allowed both for referral of projects to the Environmental Protection Authority (EPA) and establishment of the Department of Conservation and Environment. As well as providing assistance to the EPA on referred projects, the Department is concerned about a number of environmental issues associated with the gold mining industry.

Jan 1, 1982

By Walraven F, Knott G. G

Using a typical small logging instrument (Neltronic KPD), a natural gamma reference section for part of the Brockman Iron Formation and part of the Mt. McRae Shale has been established in the Newman area. This is compared with the stratigraphic type section of Trendall and Blockley (1968). Folding and faulting are recognised using natural gamma logs. Because of the confidence with which stratigraphic horizons can be identified, less expenditure on diamond and percussion drilling is required to confirm stratigraphic position. Using natural gamma logs as stratigraphic control the apparent thinning of the Banded Iron Formation during iron enrichment is Demonstrated.

Jan 1, 1973

Since 1960, the Dongchuan Copper Mining Bureau, Yunnan Province, China, has treated copper oxidised ores by sulphidisation - flotation technique only to recover copper. In order to improve the metallurgical performances and economics of flotation, extensive development work has been carried out during the past 30 years: several specific flotation flowsheets have evolved from the originally selected `stage - grinding and stage - flotation' flowsheet to suit various ores; the overall grinding size of the ores has been increased from 80 per cent - 200 mesh to 90 per cent - 200 mesh, resulting in significant increase in copper recovery; the substitution of CaS for NazS proved to be successful in sulphidisation of copper oxidised minerals, and also in avoiding the depressing effect of Na2S on copper sulphide minerals; the application of a number of activators of copper oxidised minerals, especially ethylene diamine phosphate, has considerably improved the flotation performance and decreased the consumptions of other reagents. Finally, the combined use of sodium hydroximate with butyl xanthate has been shown to be effective in enhancing the floatability of both copper oxidised and sulphide minerals.

Jan 1, 1993