Search Documents

By Yanis Miezitis, Gerald Mueller, Timothy F. McConachy, Ronald G. Sait, Keith R. Porritt, William J. McKay

In November 2004, Australia lodged with the United Nations Commission on the Limits of the Continental Shelf possible new maritime boundaries in relation to Australia’s continental shelf extending beyond 200 nautical miles from the Territorial Sea Baseline (Colwell and Symonds, 2005). If agreed by the commission, just over half of Australia’s land mass will lie below the sea, and Australia will have one of the largest marine jurisdictions in the world (14.41 million km2). With this jurisdiction comes a responsibility to manage and sustain the marine environment (McConachy, 2006). Knowledge of minerals and their resource potential is part of this responsibility but is generally poorly known (McConachy, 2005).

Aug 24, 2006

By Ian J. Graham, Cornel E. J. de Ronde

New Zealand lies astride a convergent plate boundary that extends north-eastwards from the Taupo Volcanic Zone (TVZ) to Tonga. This boundary is marked by the Kermadec arc, c. 1200 km of which falls within New Zealand’s EEZ, and which is host to numerous volcanic edifices both on the arc and in a zone immediately behind the arc to the west. In 1999, thirteen volcanic centres in the southern 260 km of the arc were surveyed for their hydrothermal plumes with seven of them discharging vent fluids into the surrounding ocean. Three of the seven volcanic centres have had mineralised rocks recovered from them during dredging and submersible operations, namely Brothers, Rumble II West and Clark. Presentday plume data combined with mineralogical evidence indicate that the vent sites at Rumble II West and Clark are waning, although the presence of Cu-rich sulphides in samples recovered from Rumble II West suggest there may be a massive sulphide (Cu-Zn-Pb-Ba ± Au) deposit located within the caldera. Brothers volcanic centre is host to the largest polymetallic mineral deposit discovered along the Kermadec arc and has numerous, up to 7 m tall chimneys within a c. 600 x 200 m area located on its NW caldera wall. Geochemical data indicate that concentrations of base metals are variable and depend critically on sample type. When combined with mineralogical and plume data, this indicates addition of a magmatic fluid component to the vent fluids.

Aug 24, 2006

By U. Schwarz-Schampera, C. Rühlemann, H. -R. Kudrass

Within 2006 BGR will conclude a contract with the UN International Seabed Authority (ISA) for the exploration of polymetallic nodules. The contract covers an area in the Pacific nodule belt between the Clarion and Clipperton fracture zones, that which is about 75.000 km2 in size at water depths between 4200 and 5000 m (see Fig. 1). Up to now, 7 consortia or state parties have acquired similar exploration “licenses” for polymetallic nodules in the central Pacific Ocean and the Indian Ocean. These licenses of the UN authority are required according to the UN convention on the law of the sea (UNCLOS) as the areas of interest are located outside of national EEZs. The “licenses” then reserve exclusive rights to the applicant for a time span of about 15 years.

Aug 24, 2006

By K. Vanstaen, K. M. Cooper, S. Ware, S. L. Boyd

Remediation and restoration of offshore marine habitats is a relatively new concept with attempts in European regions largely being instigated by requirements of various strategic directives including Article 2 of the Habitats Directive (1992), the EC Water Framework Directive (2000, Article 2 of the OSPAR Convention (1992) and the developing European Marine Strategy Directive. A field experiment to establish the practicality of various options for rehabilitating the seabed on the cessation of dredging has been successfully set-up. The purpose of this experiment is to investigate the practicality and effectiveness of gravel seeding as a potential restorative method which could be applied at marine aggregate extraction sites following cessation of dredging. Zone 2, within Area 408 (offshore Humber) was chosen as the experimental site as there is some evidence for persistence of sand which may have resulted from screening operations at this site.

Aug 24, 2006

By C. W. Devey, K. S. Lackschewitz

The mineralogy and geochemistry of hydrothermally altered wall rocks from different modern basaltic- and felsic-hosted hydrothermal fields at seafloor spreading centers and convergent margins have been studied to determine the characteristics of different types of alteration and to calculate the magnitudes of elemental exchanges between seawater and wall rock.

Aug 24, 2006

By H. Shimoda, K. Tamaki, K. Iizasa, M. Watanabe, K. Okamura

Modern Kuroko-type deposits occur in submarine calderas of island-arc fronts and back-arc rifts in Japan. They occur primarily on or adjacent to caldera boundary faults. Hydrothermal sulfides in the Myojinsho submarine caldera are one of Kuroko-type deposits, but their occurrence is different from other deposits found within the area 200 km2 around the Quaternary volcanic front of Izu-Ogasawara arc.

Aug 24, 2006

By I. Yu. Melekestseva, V. V. Zaykov

Paleooceanic structures of the Urals fold belt contain different volcanic-hosted massive sulfide deposits of the Urals, Kuroko and Cyprus types [Prokin, Buslaev, 1999]. Small Cobearing massive sulfide deposits, as Ishkinino, Ivanovka and Dergamysh, associated with ultramafites of the Main Urals fault, are less known. Interest to them had arisen after discoveries of the modern “black smokers” associated with ultramafic rocks of the Middle-Atlantic Ridge (MAR). Ores of the Urals deposits are enriched in Co (0.3 %) and Ni (0.6 %) that are concentrated in Co-Ni-Fe-sulfides, sulfarsenides, and arsenides. Ores also contain the increased gold contents – 3–6 ppm and up to 16 ppm in those saturated with As-bearing minerals. The aim of the paper is a comparison of precious metal mineralization in ores from the Paleozoic and modern ultramafic-hosted massive sulfides.

Aug 24, 2006

By Hjalmar Thiel

Issues of deep-seabed mining are discussed since four decades and extensive efforts have been invested in oceanographic studies related to environmentally sound harvesting of polymetallic nodules. Because mining on the deep seafloor seems to range from large-scale, two-dimensional dredging or scooping up of the ore from the uppermost surface sediment layer to more localized drilling or deeper digging into a three-dimensional ore body, it appears to be justified to reconsider some concepts for environmental impact evaluation. Based on the experience gained during preceding years in environmental studies related to polymetallic nodule mining, some interrelated hypotheses and proposals will be presented. It is suggested that these proposals be considered in future plans for environmental impact evaluation and that observations on community re-establishment be conducted before massive sulphide mining or other ore extractions enter the commercial mining phase.

Aug 24, 2006

By William Wiehagen

This trainer?s guide is designed as a reference manual. The purpose is to offer information and examples to skills trainers to assist them in structuring training for new operators of Walk-Thru roof bolting machines. Trainers can use this manual as a resource for helping trainees learn, understand, and apply knowledge and skills. In this sense, the guide is not prescriptive. It is designed to offer information and trigger ideas on what might be done to accelerate learning to those who are new to the roof-bolting task. On-site trainers can modify this guide to fit their conditions, machines and equipment, and work procedures. They can integrate roof control plans, company policies and procedures, and operators? manuals from the manufacturers of the original equipment into this guide. Every trainee is different and will come to the job with varying levels of relevant knowledge and skills. The trainer?s decisions on where to start, how to organize the on-the-job and classroom training portions, and when and how to offer different aspects of the training will be based on (1) a pretraining assessment of the trainee?s knowledge and skills and (2) the trainer?s experience in conducting skills training. The ?Skill Check? section might be useful for deciding where training should start among miners who have underground experience but limited knowledge of roof-bolting techniques. Every job carries a learning curve and likely has a number of ?teachable moments? where significantly new knowledge and skills can be learned.

Aug 1, 2006

By Thomas H. Dubaniewicz

The National Institute for Occupational Safety and Health, Pittsburgh Research Laboratory conducted a study of laser safety in potentially flammable environments. Researchers measured threshold igniting powers as a function of beam diameter for butane and propane-air mixtures by laser-heating targets placed on optical fiber tips using a 1064 nm laser. The minimum igniting powers for propane-air and butane-air were about 250 and 300 mW, respectively. Threshold igniting powers for propane-air were approximately proportional to beam diameter for beam diameters from 0.1 to 2.0 mm. Results suggest that relatively powerful beams may be used in these atmospheres without causing ignition, provided the beam diameter is controlled. Threshold ignition delay times using 91125 and 62.51 125 pm fibers were approximately proportional to the inverse square of the laser power. Ignition delays were about 45 ms or longer for laser powers up to 800 mW. Preproduction samples of a commercial optical fuse prevented ignitions under selected test conditions. A self-healing effect was observed for one sample. Comparisons are made with the results of other researchers. O 2006 Laser Institute of America. Key words: propane ignition, butane ignition, laser ignition, nonbeam hazards, fiber optic fuse

May 3, 2006

By Patrick M. - Langevin

THIS TALK IS ABOUT : How the DBL mining camp deposits have been found and what is done to find the next one PLAN: Overview of the geological context Historical exploration perspective Deposits geology and key features Conclusion

May 1, 2006

By Dave Stefanuto

Voisey?s Bay Project Components ? Mine/Mill Port In Labrador ? Mini Plant in Mississauga ? Demonstration Plant in Argentia ? Supply Vessel (Umiak1) ? Transshipment Facility (Quebec) ? Concentrate Handling & Transport to Sudbury/Thompson ? Cobalt Refinery Upgrade (Thompson) Project Setting ? The Project is on the traditional lands of the Labrador Inuit and the Labrador Innu ? Canadian courts have held that Aboriginal peoples in Canada possess special rights to traditional Aboriginal lands Those rights can include requiring resource developers to enter into Impacts and Benefits Agreements (IBAs) on traditional lands to set forth how lands can be used and benefits to be received by Aboriginal people

May 1, 2006

By Jason J. Crowder

Presentation Outline ? Introduction ? Costs of ground support and rehabilitation ? Why post-failure rock mass properties are necessary ? The Rock Mechanics Problem ? Present State of Modelling and Instrumentation in Mining ? Case Study Background ??Williams Mine ? Deriving Parameters for Modelling from Instrumentation ? Results from Case Study ??Back Analyses ? Discussion of Research Impact t Summary

May 1, 2006

By Rob Stewart

Acknowledgements ? Josef Macek(Manitoba Geological Services) ? Sally Goodman (SRK) ? Inco Geologists ? Rogerio Montiero ? Thompson Mine Geologists Introduction ? Regional Geology ? Thompson Geology ? Stratigraphy ? Sulphide Characteristics ? Conceptual Model ? Structural History ? Belt ? Thompson Mine ? 1D Deposit ? Ore Controlling Structures ? Using Structural Data to Guide Exploration ? Summary

May 1, 2006

By Jim Cooney

Background ?1990s saw massive changes in South African mining industry ?over 100,000 jobs lost as the industry restructured; ?1999 ?Placer Dome purchased a 50% interest in South Deep (WAL), a mine located just outside Johannesburg ?This was the first major post-apartheid foreign investment in the South African mining industry The Situation ?Placer Dome decided to lay off 2560 mineworkers (one third of the workforce) from the South Deep Mine to restore the mine to economic viability. ?Unemployment in South Africa was over 25%, and the retrenched mineworkers had few skills with which to make a living. Policy Context ?Placer Dome was committed to: ?global corporate policy of Sustainable Development, ?demonstrating that its business contributes to the economic and social progress of host jurisdictions. ?Government of South Africa was committed to ?attracting foreign investment to its mining sector with a view to modernizing and enhancing its economic and social viability, ?ameliorating the negative social consequences of structural change without arresting the necessary process of restructuring. ?National Union of Mineworkers was committed to: ?working with the mining industry and the government in implementing a Code of Good Practice on Dismissals and a Social Plan to assist retrenched mineworkers (1999).

May 1, 2006

Overview of Presentation ?About MiHR ?Human Resources Challenges in the Minerals and Metals Industry ?Getting the Facts -Sector Study Project ?Key Findings ?Recommendations ?Conclusions ?MiHR?srole

May 1, 2006

Project Located in northwestern British Columbia 70km West of Cassiar Highway Galore Creek Project and Road Access Corridors Designated For Mineral Development in Stikine-Cassiar Land Resource Management Plan (LRMP)Approved in 2000Strong BC Government, local community and Tahltan First Nation Support for Project

May 1, 2006

An essential tool for every step ? Early field survey ? Handheld satellite phones ? Portable satellite phones ? Exploration and Drilling ? Handheld satellite phones ? Portable satellite phones ? Production ? Handheld and portable ? Fixed Satellites systems ? Asset tracking systems Main applications via satellite ? Voice and Fax communication ? Internet access and E-mail ? Video conferencing ? Interconnection to mobile phones, 2 way radios, long range WIFI ? Equipment Tele-maintenance ? Telemedicine ? Crew and morale calling ? Vehicle and asset tracking

May 1, 2006

By J. Ran

Ground instability is among the major causes of serious incidents and production disruptions in the mining industry and has a significant impact on safety. Mining companies may have operations in a number of jurisdictions with varied regulatory requirements for ground control management. As these companies expand into countries where mining regulations are formative or lacking clear definition, ground control practices are usually developed by local mine personnel based on their experience. In many cases, inconsistent procedures and standards are generated, which can lead to an increase in occurrence of underground incidents due to difficulties and confusion in implementation. This situation has forced some mining companies to standardize their ground control practices by geographic regions or divisions. Though this approach is an improvement, it may not lead to effective management of ground control issues across all operations of a global mining company. Barrick Gold Corporation, with operations in North and South America, Australia and Africa, decided to adopt a global approach to ground control management. This global approach requires all Barrick operations to prepare and implement an effective ground control management plan (GCMP) based on site specific conditions and company guidelines. It is also required that the GCMP be developed through application of sound geotechnical engineering practices and be consistent with local regulatory requirements and Barrick safety policies. All Barrick underground operations have GCMPs in place, and its surface operations are now involved in the initiative. This paper presents Barrick?s global approach to underground mine ground control management and outlines the content and process for the development of a GCMP.

May 1, 2006

By Jeff Smith

Agenda About NORTHPARKES The NEED The INITIATIVE The SEARCH The PRODUCTS The SOLUTION The RESULTS The Northparkes copper-gold mine in Central Western NSW commenced operations in 1994. Copper concentrate is produced and shipped to smelters in Japan, China & India under long term contracts with spot sales to other Asian countries.

May 1, 2006