Production Engineering and Research - Selective Adsorption of Hydrocarbon and Water Vapor on Alumina at Atmospheric Pressure (T.P. 1628, Petr. Tech., Nov. 1943)

The American Institute of Mining, Metallurgical, and Petroleum Engineers
Chen Chun Ku R. L. Huntington L. S. Reid
Organization:
The American Institute of Mining, Metallurgical, and Petroleum Engineers
Pages:
13
File Size:
498 KB
Publication Date:
Jan 1, 1944

Abstract

The simultaneous adsorption of water and hydrocarbon vapor from natural gas by three grades of alumina has been studied at atmospheric pressure and temperature. Results of this investigation reveal that the presence of water vapor in the gas inhibits the adsorption of hydrocarbon vapor, although the presence of the latter does not have a pronounced effect upon the adsorption of water vapor. Adsorption of water-hydrocarbon mixtures from gas is divided into three phases. In the first, both water and hydrocarbon vapor are adsorbed; in the second, adsorption of water vapor proceeds while desorption of hydrocarbon takes place; in the third phase, the adsorbyt approaches complete saturation with respect to both water and hydrocarbon vapors. Both theory and experimental data can be applied to design and operation of commercial dehydration plants, and an illustration is presented. Introduction Dehydration of natural gas becomes increasingly important as the operating pressures employed in gas processing and transmission are increased above 500 ib. per sq. in. Gas produced from high-pressure wells is saturated with water vapor when it leaves the reservoir and it continues into the processing plant or transmission system in a saturated condition because of the substantial decrease in temperature due to expansion at the wellhead. Usually this gas is accompanied by liquid water and hydrocarbons that have condensed with the change in temperature and pressure. Without dehydration, gas temperatures must be held at relatively high levels to prevent solidification of gas hydrates. According to Hammerschmidt's data8 on the relationship of pressure to the freezing point of natural-gas hydrates, the minimum safe operating temperatures range from 55' to go°F. for pressures ranging from 500 to 3000 lb. per sq. in., respectively. Often it is difficult to maintain gas temperatures above the hydrate-freezing temperature because of climatic conditions, unless flow-line heaters are installed. Also, in processing gas for its gasoline content at high pressures, it is desirable to employ operating temperatures lower than the hydrate-freezing point. In distributing high-pressure gas, the large pressure drop from line pressure to town-gate pressure often prbduces sufficient cooling to freeze the regulators and disrupt consumer service. Therefore, it is highly essential to dehydrate high-pressure natural gas if smooth and economical operation is to be maintained at all times. Few published data are available on the simultaneous adsorption of water and hydrocarbon vapors. The literature contains many mathematical expressions for rate of adsorption in various systems but a rational correlation of the existing rate
Citation

APA: Chen Chun Ku R. L. Huntington L. S. Reid  (1944)  Production Engineering and Research - Selective Adsorption of Hydrocarbon and Water Vapor on Alumina at Atmospheric Pressure (T.P. 1628, Petr. Tech., Nov. 1943)

MLA: Chen Chun Ku R. L. Huntington L. S. Reid Production Engineering and Research - Selective Adsorption of Hydrocarbon and Water Vapor on Alumina at Atmospheric Pressure (T.P. 1628, Petr. Tech., Nov. 1943). The American Institute of Mining, Metallurgical, and Petroleum Engineers, 1944.

Export
Purchase this Article for $25.00

Create a Guest account to purchase this file
- or -
Log in to your existing Guest account